This is how a 3D printer saved a newborn baby’s life

Doctors in the US have used 3D printed models of the foetus face to determine the necessity of a lifesaving delivery procedure in a baby with a life-threatening lump on its face.

US doctors were able to 3D print a model of the foetus face using an MRI scan to determine exactly how dangerous a walnut-sized lump on its face was. The baby, when it was born, was healthy. (Image is representative) (Shutterstock)

Megan Thompson was about 30 weeks pregnant when an ultrasound showed a walnut-sized lump on her tiny, unborn child's face that could prevent him from breathing after birth.

Thompson was referred to the University of Michigan's CS Mott Children's Hospital where doctors had to decide whether baby Conan could be delivered safely through a C-section or needed a rare and complex lifesaving procedure. The tool they used to help make that difficult decision -- 3D printing.

Using a specialised MRI of the foetus in the womb, doctors were able to use a 3D printer to print models of the foetus face, helping determine exactly where and how dangerous the soft tissue mass was.

"Based on the images we had, it was unclear whether the mass would block Conan's airway after birth. The 3D printed model of the foetus allowed us to actually see in person what it looked like and have something in our hands to help us decide the best way to care for the baby," said senior author Glenn Green, associate professor of paediatric otolaryngology at U-M's CS Mott Children's Hospital.

"This is the first case we are aware of that 3D printing has helped show how severe an airway risk in a foetus was in order to make clinical decisions. 3D printing may be an incredibly valuable tool to help doctors prepare for complex cases ahead of birth," said Green.

The extra information gained from the 3D printed models helped doctors determine that Conan would not need what's called an Ex Utero Intrapartum Treatment Procedure (EXIT). The EXIT procedure requires a partial delivery of the baby while it remains attached by its umbilical cord to the placenta so that a surgeon can establish an airway to allow the baby to breathe. Instead, Conan was born via a scheduled C-section.

"I was terrified when I found out there was a possibility my baby might not be able to breathe after birth," said Thompson, of Wayne County, Michigan. "Hearing him cry after he was born was the most incredible, emotional experience because I knew he was OK," she said. "They told me the 3D printed models would help give them a more accurate idea of what was going on and what kind of delivery I should have," said Thompson. "I was relieved that I didn't need the more complicated and risky surgery and could be awake for the birth of my first baby. I'm glad that what they did for Conan may help other babies and their families in similar situations," she added.